Drive-in Test Chambers is the chamber where all kinds of land vehicles can enter
and environmental conditions are tested.
We produce Drive-in Test Chamber according to

• ISO 11507 - ISO 4892-3
• ASTM D4799
• ASTM D6662
• ASTM G154
• ASTM D4587
• SAE J2020
• J15 K 5600-7-8
• EN 927-6
• AATCC TM186

Drive-in Test Chamber is provided by creating the following circuits.

• Cooling -45 C cooling circuit.
• Heating +60 ºC special heaters.
• Temperature stability: ± 1 ° C
• The heating and cooling rate are on average 5 ° C / minute.
• Humidification 20% Rh% to 98% Rh
• Drive-in Test Cabinet is controlled by our own software, using PLC.
• UV Solar Radiation or IR light.

The Drive-in Test Chambers can create a test cycle with programming, so customers can initiate a test simply by selecting the program.

Climatic Test Chambers are used to test the effects of certain environmental conditions on biological products, industrial products, materials and electronic devices and components.

The material placed in the Standard Test Chamber provides the environmental conditions to which devices or components may be exposed. It is also used to accelerate the effects of exposure to heat change in the environment under unexpected conditions.

To create an environmental impact on the world, -80°C /+200°C / %20Rh/ %98Rh.

Test Chambers usually have windows and lighting for sample observation or video can be used in special cases. Systems allow observation. Standard Climatic Test Chambers can create a test cycle by programming, so customers can start a long test by simply selecting the program.

We produce rain test chamber according to Procedure I - II - III.


Procedure 1:
Rain and Windy Rain. It is the test applied for products that are not protected from rain and will be placed outside can be changed from stagnation to high level by choosing the accompanying wind speed. Rain amount minimum 2.90 mm/min. is used.
Droplet size 2.70 mm

Procedure 2:
Exaggerated Rain This procedure stimulates the natural amount of rain, giving a very high degree of confidence in the waterproofing of the product under test. 2.76 bar spray pressure 20.8 liters/min. The water droplet speed is 86 km/h.

Procedure 3:
Dripping. It is only applied to products that are likely to be exposed to precipitation due to leakage on the upper surface of the tested product.

The Rain Test Chambers are controlled by our own Software, using a PLC.

Your products must withstand different temperatures during use, transportation, and storage due to seasonal differences or different climatic conditions.

The Walk-in Chambers help you to test the influence of temperature and humidity on the properties, function, and lifespan of your products.

We produce test chamber according to
EN-ISO 17025 standard.
Test chamber made of highly-alloyed, extra corrosion-resistant stainless steel.
Temperature changes in the range from -30 °C to +70 °C can be realized.
Humidity range 20% Rh to 98% Rh
Temperature stability: ± 0.5 ° C
Air velocity can be adjusted from 0.05 m / h - 0.25 m / h Heating and cooling rate is on average 0.5 ° C / minute.

Walk-in Test Chambers are controlled by our own software, the user interface allows you to program, control and monitor your tests at any time and anywhere – even from home, even from a mobile device.

The Calorimetric Test Chamber is produced according to SO 17025 / ISO 15042 / ISO 6298 / ISO 5806 Standards.

Calorimetric Test Chambers are controlled by our own software, the user interface allows you to program, control and monitor your tests at any time and anywhere – even from home, even from a mobile device.